SEARCH

COAL BURNER VALVES FOR A COAL FIRED POWER STATION

18th Feb 2016

The conversion from coal to renewable wood chip requires specialist knife gate valves that are machined and then stellite welded to create a matched internal bore identical to the basalt lined pipe commonly used on these very abrasive transfer lines, the design also allows for a potential explosion pressure of 13.5 bar (in this case) as stated within NFPA 8503. These 306mm valves are part of a total requirement of 96.

Share this item

Our Website uses cookies to improve your experience on our Website.
Click here to read our cookie policy.

Indicate your acceptance by clicking OK